How to use? DermaGene EyeLifter 4in1

Use of the device

  1. Remove make-up and various impurities from around the eyes, cleanse the skin with a facial cleanser.
  2. Apply 2-3mm of ultrasonic conductive gel (e.g. DermaGene Hyaluronic Acid Conductive Gel or simple medical ultrasonic conductive gel) to the treatment area. It is IMPORTANT to have a conductive gel on the area to be treated at all times, as this is the only way the micro-current and radiofrequency can penetrate the skin. (Tip! As the device can also inject active ingredients using alternating current, a good conductive serum can be applied under the conductive gel to increase effectiveness. Choose a super serum or an active ingredient conductive gel and take your firming treatment to the next level at home.)
  3. Press and hold the on/off button for 2 seconds to switch the device on.
  4. Use the On/Off button to select the desired treatment mode
    1. Mode: EMS + Radio Frequency
    2. Mode: EMS + Radio frequency + LED light
    3. Mode: EMS + Radio frequency + LED light + Vibration
  5. Slowly move the device in a circular and/or pulling motion on the area around the eye (see figure below), along the eyelid and eyebrow line. Work slowly, using light pressure and gentle motions. Slight redness is normal. (IMPORTANT! Do not work directly on the eyelid and eyeball)
  6. Apply the device to the area around both eyes for 1-1 minute on the first treatment. Gradually increase the application time.
  7. Repeat the treatment until the skin becomes red or cause discomfort.
  8. After use, switch off the device by pressing and holding the on/off button and clean the end of the handpiece. Wipe off the conductive gel completely and wipe the electrodes with a cloth soaked in surface disinfectant. Do not immerse the device in water and do not wipe it with a very wet cloth. Strong disinfectant may damage the electrodes.

 

 

During treatment:

  • always keep the handpiece moving on your facial skin (never keep it in one place on your skin)
  • keep increasing the number of passages from treatment to treatment, i.e. gradually accustom your skin to the treatment. The longer the treatment, the more passes and the higher the heat achieved, the better the result due to the collagen denaturation and the muscle stimulation and circulation acceleration caused by EMS.
  • use gentle circular and back and forth pulling movements with light pressure
  • never use the device without a conductive gel on dry skin (DermaGene® Hyaluronic Acid Conductive Gel)
  • always apply the treatment on clean skin

 

After treatment:

  • avoid strong sunlight and sunbath for 24 hours
  • apply a minimum of 30SPF sunscreen for 3-4 days
  • avoid sauna, strong steam or heat on the skin for 24 hours (avoid wellness for 1 day)
  • moisturize your skin generously (we recommend our DermaGene® Masks)
  • for collagen production, drink large amounts of pure water every day to bind fresh collagen water
  • apply a high dose of vitamin C to stmulate collagen production (we recommend our AURORA Collagen Lemonade Powder, which contains collagen, hyaluronic acid, zinc and vitamin C)